assembly Instructions

- 56 -

Sequency timing:

Parameter Number Size Range Default

15 ( SEQUENCY_TIME ) 1 10 – 50 10

Time in [100 miliseconds] of maximum delay between BASIC ON and BASIC

OFF (and vice versa) to relay endpoint to consider this as a sequence. It is

typically 1 second, but can be exceptionally longer due to retransmissions and

overload – in this case, a longer interval can be allowed (up to 5 seconds).

Motion O behaviour (timeout):

Parameter Number Size Range Default

16 (MOTION_DISABLE) 2 0 – 209, 255 0

Motion disable timeout after BASIC SET to motion endpoint when the internal

motion sensor is not used for evaluating the behaviour of the relay and groups

2 and 3. Events are, however, still transmitted to the Lifeline, and the relay can

be controlled via remote motion sensors.

BASIC SET to Motion sensor endpoint ignored, BASIC to root is

mapped to relay endpoint, motion sensor still enabled

1 -209

Internal motion sensor is disabled for speciﬁed timeout after BASIC

SET 0x00 to Mootion sensor endpoint. BASIC to root is mapped to

Motion sensor endpoint.

Timeout:

1..100 – 1 second (1) to 100 seconds (100) in 1-second resolution

101..200 – 1 minute (101) to 100 minutes (200) in 1-minute resolution

201..209 – 1 hour (201) to 9 hours (209) in 1-hour resolution

210-254 Reserve

255

BASIC SET to Motion sensor endpoint ignored, BASIC to root is

mapped to relay endpoint, motion sensor still disabled