HFLUM2-WR English Installation Instructions Fixture Integrated Sensor Module Français Consignes d’Installation Fixture Integrated Sensor Module Contains: FCC ID - W8J-SIR13 IC - 8529A-SIR13 RoHS Compliant Made in Romania
WARNING • Turn power off at the circuit breaker before installing the sensor • Sensor module must be installed and used in accordance with appropriate electrical codes and regulations • Installation by a qualified electrician is recommended Package Contents • One HFLUM2-WR • Installation Instructions Installation Overview Needed for installation Usage considerations Continued • Two mounting screws • Consider the interaction between various OEM components such as ballast and lamp types.
120-277 VAC 50/60Hz HF 5.8 GHz 3.3 - 13 ft 1-4m Product Overview Fixture integrated 3.3 - 26 ft 1-8m 360° Product description The HFLUM2-WR is a line voltage occupancy sensor module that installs in a fixture, adding energy saving lighting control in each fixture location. The sensor uses STEINEL’s High Frequency (HF) technology to turn lighting on and off based on occupancy. Also, it holds lights off when sufficient daylight is present.
Mounting Mounting guidelines • The sensor module is intended to be installed within a luminaire. Its dome antenna must face the desired area of detection (the fixture’s area of illumination). • Suitable for wall and ceiling applications. • For indoor use only • For optimal coverage, the dome antenna must project beyond the lamps and should not be blocked by any metal. • The dome antenna must have an unobstructed view of the detection area.
Operation Surge protection The HFLUM2-WR operates by turning lights on automatically when occupancy is detected and off when the space is left vacant and the time delay has elapsed. Every sensor contains built in surge protection. This feature will reset the unit automatically after: power surges, power outages, and power shortages. Surge protection protects the sensor if it is miswired as well. If miswired, shut off power, correct the wiring, and the sensor will then operate correctly.
Setup & Commissioning Coverage size 3.3 - 13 ft 1-4m The HFLUM2-WR coverage is 360° and its reach ranges from 3.3 to 26 feet (see next page for reach/sensitivity adjustment). Actual coverage may vary depending on luminaire configuration and environmental conditions. 3.3 - 26 ft 1-8m Lamp seasoning Test mode Some florescent lamp manufacturers recommend seasoning or “burning in” lamps. To meet this recommendation, the following seasoning procedure should be carried out for new fluorescent lamps.
Setup & Commissioning (continued) Sensitivity: adjusts coverage reach from approx 3.3 feet to 26 feet Light level: .2 (night) to 200 (day) footcandles Time delay: 30 seconds to 30 minutes Light level The light level feature allows lighting to remain OFF during daylight, regardless of occupancy. Daytime operation is at 200 footcandles (factory setting). Nighttime operation is at .2 footcandles. The adjusting screw turned fully clockwise means daylight operation at approx. 200 fc (factory setting).
Troubleshooting Malfunction No power at the sensor Cause Remedy breaker has tripped; light switch is in OFF position short circuit Lights do not switch ON reset breaker, turn light switch to ON position, check wiring with voltage tester check for proper wiring connections light level setting is in nighttime mode during daytime operation lamp burned out power is off detection zone not correctly adjusted adjust light level setting Lights do not switch OFF sensor is detecting movement outside of de
USA - Bloomington, MN 55420 Tel: +1-952-888-5950 Fax: +1-952-888-5132 www.steinel.net Technical changes subject to no prior notification. STEINEL America Inc.
