Certifications 2

according to Regulation (EC) No 1907/2006
Safety Data Sheet
STEINEL GmbH
Klebestick 11mm
Revision date: 13.03.2018 Product code: Page 4 of 8
Suitable respiratory protective equipment: particulates filter device (DIN EN 143). Type: P1-3
The filter class must be suitable for the maximum contaminant concentration (gas/vapour/aerosol/particulates)
that may arise when handling the product. If the concentration is exceeded, self-contained breathing apparatus
must be used. Observe the wear time limits according GefStoffV in combination with the rules for using
respiratory protection apparatus (BGR 190).
This material and its container must be disposed of in a safe way.
Environmental exposure controls
-
solid
Physical state:
Colour:
9.1. Information on basic physical and chemical properties
SECTION 9: Physical and chemical properties
characteristic
Odour:
pH-Value:
not applicable
Changes in the physical state
not determined
Melting point:
not applicable
Initial boiling point and boiling range:
not determined
Sublimation point:
not determined
Softening point:
not determined
Pour point:
>200 °CFlash point:
Sustaining combustion:
No data available
none
Explosive properties
not determined
Lower explosion limits:
not determined
Upper explosion limits:
>250 °CIgnition temperature:
Auto-ignition temperature
not determined
Gas:
not determined
Decomposition temperature:
none
Oxidizing properties
Vapour pressure:
not determined
Density:
not determined
Bulk density:
not determined
Water solubility:
insoluble
Solubility in other solvents
not determined
not determined
Partition coefficient:
Viscosity / dynamic:
not determined
Viscosity / kinematic:
not determined
Flow time:
not applicable
Vapour density:
not applicable
not applicable
Evaporation rate:
not applicable
Solvent separation test:
GB - EN Print date: 14.03.2018Revision No: 2,0