Virtual Guitarist 2

ENGLISH
Virtual Guitarist
English 53
Proceed as follows to set up the Delay:
1. First select the effect type with the effect switch.
• Mono: The signal is repeated at the interval set with the time knob.
• 3 tap: A delay with 3 separate circuits, forming a complex rhythmic pattern.
• Multi: This is the typical tape echo effect simulating multiple playback heads.
Within the time interval the signal is played back by four separate tape heads.
• Stereo: The echoes alternate between left and right in the stereo panorama
2. Set the delay time with the Time knob. When Sync is deactivated, the
display unit is seconds.
3. The Mix knob determines the balance between the dry and the effect
signal.
4. The Feedback (FBK) knob sets the number of delay repetitions (tech-
nically this is the amount of the effect signal that is fed back to the in-
put). Very high feedback values can lead to an increasing delay level
and finally create distortion—this can be wanted, however, for dub or
psychedelic delay effects.
5. Vintage controls the “age” of the effects unit (between ultra-clean dig-
ital delay and worn-out tape echo). Higher values introduce a loss of
frequency response accompanied by tape flutter, leading to a slightly
detuned and less brilliant effect signal. Even pseudo reverb effects
are possible.
Reverb
This device is a dedicated guitar reverb rather than a reverb unit for
general mixing purposes.