Virtual Bassist

Virtual Bassist
56
Effect routing
Routing display
The effect routing is set up in the most efficient way. All effects are
connected in series in the following order:
Activated effects are highlighted in the routing display.
Routing switch
If you take a closer look at the FX Routing you will notice that EQ and
Compressor are available at two positions in the chain. Depending on
the sound you’re aiming for, you might want to have the EQ and the
Compressor in front of the other effects or after them.
To manage the signal flow of the effect board and the position of the
DI (Direct Injection) box – pre or post Drive – the amp section has
three routing switches.
For example you want...
1. …the Chorus to affect the compressed signal (Compressor pre).
2. …to compress an already chorused signal (Compressor post).
3. …to mix a clean DI signal with the overdriven signal from a mic’d
cabinet (DI pre).