Hypnotic Dance

6
Amp section
In the Amp section, the following parameters are available:
Level
Adjusts the level of the program. If you add distortion to the filter by increasing the Drive parameter, you may have to ad-
just the level to compensate for an increase in gain.
Attack
Increases or decreases the attack time of the amplifier envelope. Positive values decrease the attack time.
Release
Increases or decreases the release time of the amplifier envelope. Positive values decrease the release time.
StepModulator section
Many of the programs of Hypnotic Dance VST Sound Instrument Set make use of a StepModulator to add rhythmic
modulations. Up to 32 steps can be defined and edited. In the StepModulator section, the following parameters are
available:
Step
Allows you to select a step.
Level
Shows the level of the selected step. The level can be adjusted by entering a value in the text field.
When Snap is activated, the level of each step can only be adjusted in steps of 1/12.
Steps
Sets the number of steps the sequence plays.
StepModulator presets
Use the pop-up menu at the top of the StepModulator section to load and save presets.
• To load a preset, click the Select Preset field and select a preset.
• To delete a preset, click the trash icon.
• To save a new preset, click the floppy disk icon.
Graphical step display
In the graphical step display you can edit steps using the mouse and/or the computer keyboard. Proceed as follows:
• Set the level of a step by clicking and dragging in the graphical editor.
• Reset a step to a level of 0 % by [Ctrl]/[Command]-clicking the step.
• Reset all steps by [Shift]-[Ctrl]/[Command]-clicking the graphical editor.
• Adjust all steps at once by [Shift]-clicking and dragging a step.
• Draw a ramp of steps by [Alt]/[Option]-clicking and drawing a line.