User manual

nect plug-in. It displays several LEDs which indicate the connection qual-
ity for the studio and the performer side. The two rightmost LEDs should
always be green to indicate that data is received, sent, and that both
sides of the connection are in sync. It is normal, however, for the sync
indicators to light up red during transport operations like start, stop, and
locate.
The two bar graphs show how well the two partners are synchronized
during playback and recording. You can see how much audio data is
available per half second on either end. If either of these meters show
too small a value or drain entirely, dropouts in audio are to be expected.
In this case you are advised to increase the "Remote Latency" setting
and/or audio and video upstream settings as described in the CONFIG-
URATION section.
Note
The MIDI indicators show MIDI activity on either side.
2.9 Setup Tabs
You access the Setup Tabs by clicking the gearwheel icon on the lower
right of the VST Connect edit window.
2.9.1 Configuration
This tab controls settings for the VST Connect plug-in on the Cubase /
Nuendo engineer side:
21