User manual

VST Connect
Event Monitor
19
The event monitor section is located on the top middle of the VST Connect plug-in.
It displays several LEDs which indicate the connection quality for the studio and the
performer side. The three LEDs should always be green to indicate that data is
received, sent, and that both sides of the connection are in sync. It is normal,
however, for the sync indicators to light up red during transport operations like start,
stop, and locate.
The two bar graphs show how well the two partners are synchronized during
playback and recording. You can see how much audio data is available per half
second on either end. If either of these meters show too small a value or drain
entirely, dropouts in audio are to be expected. In this case you are advised to
increase the "Remote Latency" setting and/or audio and video upstream settings as
described in the CONFIGURATION section.
NOTE
The MIDI indicators show MIDI activity on either side.