User Manual

Appendix
UR28M Operation Manual 31
*1The following chart indicates the Ch.Strip (Channel Strip) insertion location.
You can apply four Channel Strips to mono channels, or two Channel Strips to a stereo channel.
*2 One of the MIX 1–3 signals can be sent to the REV-X.
*3 The built-in REV-X is equipped with an “FX Bus” which is used for sending the signal from DAW software to
the REV-X. For example, to send the recorded audio data to the REV-X, you can check the sound with the
REV-X, which is used for monitoring during the recording.
*4 To select the output signal for LINE OUTPUT A–C, use the buttons on the device . The following charts
indicate the structures.
Alternate mode
Independent mode
Ch. Strip
Ch. Strip
Upper (INS.FX)
From input on the device
To DAW
input
To DAW
input
To DAW
input
To output on the device
Lower (MON.FX)
From input on the device
To output on the device
Not applied (OFF)
From input on the device
To output on the device
MIX 3
MIX 2
MIX 1
To LINE
OUTPUT A
To LINE
OUTPUT B
To LINE
OUTPUT C
OUTPUT
button
A
OUTPUT
button
B
OUTPUT
button
C
SOURCE
SELECT
button
MONO
MIX
button
MUTE
button
OUTPUT
LEVEL
knob
DIM
button
MIX 3
OUTPUT button A
LINK
OUTPUT button B
OUTPUT button C
MIX 2
MIX 1
SOURCE
SELECT
button
MONO
MIX
button
MUTE
button
OUTPUT
LEVEL
knob
SOURCE
SELECT
button
MONO
MIX
button
MUTE
button
OUTPUT
LEVEL
knob
SOURCE
SELECT
button
MONO
MIX
button
MUTE
button
OUTPUT
LEVEL
knob
DIM button
To LINE
OUTPUT A
To LINE
OUTPUT B
To LINE
OUTPUT C