User Manual

Usage Examples
UR28M Operation Manual 26
8. Click “Record” to start the recording.
9. After finishing the recording, click “Stop” to
stop it.
10. Turn “Monitor” off (dark) for the audio track.
11. Click the Ruler to move the project cursor to
the desired point for starting playback.
12. Click “Play” to check the recorded sound.
When listening to the sound over monitor
speakers, adjust the output signal level by the
OUTPUT LEVEL knob on the device.
Operation is now completed.
Programs Other Than Cubase Series
1. Launch your DAW software.
2. Open the dspMixFx UR28M.
For instructions on how to open the dspMixFx
UR28M, refer to the section “How to Open the
Window” (page 11).
3. Adjust the input signal level of the
microphone by the INPUT GAIN knob on the
device.
Adjust the input signal level so that the red
lamp in the INPUT meter does not light.
4. Adjust the output signal level of the
headphone by the PHONES knob on the
device.
5. Set the Channel Strip settings and REV-X
settings on the dspMixFx UR28M.
6. Start recording on your DAW software.
7. After finishing recording, stop it.
8. Playback the newly recorded sound to
check it.
Operation is now completed.
Controlling the Monitor Sound
This section shows how to control the monitor sound
by using the buttons and knobs on the device.
Connection Example
Monitor speakers Monitor speakers
Portable audio player Computer