User Manual

Panel Controls for the Software Programs
UR28M Operation Manual 23
REV-X
This is the window for configuring the REV-X
settings. Three types of REV-X are available: Hall,
Room, and Plate.
NOTE
•The REV-X equipped with the device and REV-X of
the VST Plug-in version have the same parameters.
However, the “OUTPUT” and “MIX” parameters are
only available in the VST Plug-in version.
•When using the REV-X on Cubase series
programs, you can share the settings between the
built-in REV-X and the REV-X of the VST Plug-in
version as a preset file.
•When using the built-in REV-X on Cubase series
programs, turn on the “Direct Monitoring” setting in
the program.
•When assigning the REV-X of the VST Plug-in
version to the effect slot on Cubase series
programs, select it from the “Reverb” category (in
the case of the default settings).
•The built-in REV-X is equipped with an “FX Bus”
which is used for sending the signal from DAW
software to the REV-X. For example, to send the
recorded audio data to the REV-X, you can check
the sound with the REV-X, which is used for
monitoring during the recording.
Screenshot
How to Open the Window
From Dedicated Windows for Cubase
Series
•Click “REV-X Edit” (page 19) in the section “Input
Settings Window.”
•Click “REV-X Edit” (page 19) in the section “Reverb
Routing Window.”
From the dspMixFx UR28M
Click “REV-X Edit” (page 14) in the section “Master
Area.”
Panel Controls
NOTE
This section uses the Hall type of REV-X as an
example.
1 Reverb Time
Adjusts the reverb time. This parameter links to
Room Size. The adjustable range varies
depending on the REV-X type.
2 Initial Delay
Adjusts the time that elapses between the direct,
original sound and the initial reflections that follow
it.
Range: 0.1 msec – 200.0 msec
3 Decay
Adjusts the characteristic of the envelope from
the moment the reverberation starts to the
moment it attenuates and stops.
Range: 0 – 63
REV-X type Range
Hall 0.103 sec – 31.0 sec
Room 0.152 sec – 45.3 sec
Plate 0.176 sec – 52.0 sec