User Manual

Panel Controls for the Software Programs
UR28M Operation Manual 18
The Input Settings window appears in the VST Input
Channel Settings window as shown below.
In the VST Audio Channel Settings Window
(other Cubase series software)
1. Click the audio track from the track list.
2. Click “Edit Channel Settings” in the audio
track.
The Input Settings window appears in the VST Audio
Channel Settings window as shown below.
Hardware Setup Window
[Devices]  [Audio Hardware Setup]
Panel Controls
Input Settings Window
1 +48V
Indicates the on/off status of the phantom power
function of the device.
2 Phase
Turns on (lit) and off (dark) the phase inversion of
the signal.
3 High Pass Filter
Turns on (lit) and off (dark) the high pass filter.
To select the cutoff frequency of the high pass
filter, use the “Settings Window” (page 20) in the
section “Dedicated Windows for Cubase Series.”
4 Channel Strip Edit
Opens the “Channel Strip” (page 20) setup
window.
5 DRIVE
Adjusts the degree to which the compressor is
applied. The higher the value, the greater the
effect.
Range: 0.00 – 10.00
6 MORPH
Adjusts the Channel Strip Sweet Spot Data.
(Refer to the “MORPH” in the section “Channel
Strip” on page 20.)