User Manual

Using with a Computer

UR-RT4 / UR-RT2 Operation Manual

8. Click [I] to start the recording.

9. After finishing the recording, click [J] to stop it.

10. Turn [Monitor] off (unlit) for the just recorded

audio track.

11. Click the Ruler to move the project cursor to the

desired point for starting playback.

12. Click [R] to check the recorded sound.

When listening to the sound over monitor speakers,

adjust the output signal level by the [OUTPUT] knob on

the device.

The recording and playback operations are now

complete.

For more detailed instructions on using Cubase series

programs, refer to the PDF manual, available from [Help]

in the Cubase series menu.

Programs Other Than Cubase Series

1. Launch your DAW software.

2. Open dspMixFx UR-RT.

For instructions on how to open dspMixFx UR-RT, refer

to the section “How to Open the Window” (page 11).

3. Adjust the input signal level of the microphone

with the [GAIN] knob on the device.

4. While singing into the microphone, adjust the

output signal level of the headphones with the

[PHONES] knob on the device.

5. Set the Channel Strip settings and REV-X

settings on dspMixFx UR-RT.

6. Start recording on your DAW software.

7. After finishing recording, stop it.

8. Playback the newly recorded sound to check it.

For more detailed instructions on using the DAW software,

refer to your particular DAW’s software manual.

Setting optimum recording levels

Adjust the gain knobs so that the [PEAK] indicator flashes

briefly at the loudest input volume.