User Manual

Using with a Computer
UR-RT4 / UR-RT2 Operation Manual 28
Configuring Audio Driver Settings
on the DAW Software
Cubase Series Programs
1. Make sure that all applications have been closed.
2. Make sure that the [ ] switch has been turned
on (
O).
3. Double-click the shortcut of Cubase series on the
desktop to start Cubase.
4. When the [ASIO Driver Setup] window appears
while the Cubase series program is launching,
confirm that the device is selected, then click
[OK].
The audio driver settings are now complete.
Programs other than Cubase Series
1. Make sure that all applications have been closed.
2. Make sure that the [ ] switch has been turned
on (
O).
3. Launch the DAW software.
4. Open the audio interface settings window.
5. (Windows only) Select the ASIO Driver for the
audio driver settings.
6. Set the ASIO Driver for Windows and audio
interface for Mac as follows
Windows
Set the [Yamaha Steinberg USB ASIO] to the ASIO Driver
settings.
Mac
Set the UR-RT to the audio interface settings.
The audio driver settings are now complete.
Recording/Playback
This section explains simple recording operations for
using a microphone. Connect a microphone as shown in
the connection examples (pages 26, 27). Turn the [+48V]
switch on when using a phantom powered condenser
microphone.
Cubase Series Programs
1. Launch the Cubase series DAW.
The [steinberg hub] window appears.
2. Select the project template [Steinberg UR-RT
Vocal-Inst Recording 1-C7] in [Recording] on the
[steinberg hub] window, then click [Create].
3. Turn on Direct Monitoring as follows.
[Studio]  [Studio Setup]  [Yamaha Steinberg USB
ASIO](Windows) or [Steinberg UR-RT](Mac)
 enter
checkmark to [Direct Monitoring]
 [OK]
4. Confirm that the [Record Enable] and [Monitor]
indicators are turned on (lit) for the audio track.
5. While singing into the microphone, adjust the
input signal level of the microphone with the
[GAIN] knob on the device.
6. While singing into the microphone, adjust the
output signal level of the headphones with the
[PHONES] knob on the device.
7. Set the Channel Strip settings and REV-X
settings on the Input Settings window.
Select the Channel Strip Insertion location depending
on the desired insert point. The default setting is
“Lower” (applied to both the monitor signal and the
recording signal). For details on the Insertion location,
refer to the “Effect Insertion location” (page 17) in the
section “Dedicated Windows for Cubase Series.”
Setting optimum recording levels
Adjust the gain knobs so that the [PEAK] indicator flashes
briefly at the loudest input volume.