User Manual

Software
UR-RT4 / UR-RT2 Operation Manual 12
Main Window
This window is for configuring the entire signal flow.
Channel Area
This is the area for configuring the input channel settings.
1 Channel Link
Turns on (lit) and off (unlit) the channel link function of two
adjacent channels. When this is on, two mono channels
will become one stereo channel.
2 Level Meter
Indicates the signal level.
3 High Pass Filter
Turns on (lit) and off (unlit) the high pass filter (not
available on [LINE INPUT 5/6] {[LINE INPUT 3/4]}). To
select the cutoff frequency of the high pass filter, use the
“Setup Window” (page 14) in the section “dspMixFx UR-
RT.”
4 Phase
Turns on (lit) and off (unlit) the phase inversion of the
signal.
5 Effect Insertion location
Selects the insertion location of an effect.
6 Effect On/Off
Turns the Effect on (lit) and off (unlit).
7 Effect Edit
Opens (lit) and closes (unlit) the selected effect setup
window.
8 Effect Type
Select the effect type.
Options: ChStrp, Clean, Crnch, Lead, Drive
NOTE
The maximum number of Channel Strip and Guitar Amp Classics
iterations which can be used simultaneously is limited. Refer to the
“Limitations on the use of effects” (page 36).
9 REV-X Send
Adjusts the signal level which is sent to REV-X.
Range: - ∞ dB − +6.00 dB
) Pan
Adjusts the pan.
Range: L16
− C − R16
! Mute
Turns the mute function on (lit) and off (unlit).
@ Solo
Turns the solo function on (lit) and off (unlit).
# +48V
Indicates the on/off status of the phantom power function
of the device.
$ Fader
Adjusts the signal level.
Range: - ∞ dB
− +6.00 dB
Channel Area (page 12) MIX Area (page 14)
DAW Area (page 13)
Master Area (page 13)
Headphone Area (page 14)
2
6
5
8
3
1
4
7
$
9
)
!
@
#
Options Description
MON.FX Applies an effect to only the monitor signal
(sent to the device).
INS.FX Applies an effect to both the monitor signal
(sent to the device) and the recording signal
(sent to the DAW software).