User Manual

Panel Controls and Terminals (Details)
UR824 Operation Manual 7
• Do not connect or disconnect a device while
phantom power is applied. Doing so can damage the
connected device and/or the unit itself.
• To protect your speaker system, leave the monitor
speakers turned off when switching the phantom
power on/off. It’s also a good idea to turn all output
volume controls down to their minimum. Neglect of
these precautions may result in large noise bursts
that may damage your equipment, your ears, or both.
7 PHONES knob 1/2
Adjusts the output signal level of PHONES 1/2.
This output signal level is not affected by the
OUTPUT LEVEL knob.
PHONES 1/2 output one of the MIX 1–4 signals.
To select the output signal, use the “Headphone
Area” (page 13) in the section “dspMixFx UR824”
or the “Headphones Window” (page 18) in the
section “Dedicated Windows for Cubase Series.”
8 PHONES 1/2 (phone type, stereo)
For connection to a set of headphones.
PHONES 1/2 output one of the MIX 1–4 signals.
To select the output signal, use the “Headphone
Area” (page 13) in the section “dspMixFx UR824”
or the “Headphones Window” (page 18) in the
section “Dedicated Windows for Cubase Series.”
9 Word clock source lamp
Indicates the word clock (page 31) source of the
device.
To select the clock source of the device, use the
“(device name) Window” (page 8) in the section
“Control Panel of the Audio Driver” in Windows or
Audio MIDI Setup in Mac.
) Sample rate lamp
Indicates the sample rate of the device.
To select the sample rate of the device, use the
“(device name) Window” (page 8) in the section
“Control Panel of the Audio Driver” in Windows or
Audio MIDI Setup in Mac.
! OUTPUT LEVEL knob
Adjusts the output level of the LINE OUTPUT 1–8
signals.
To select the LINE OUTPUT for adjusting the
output signal level, use the “Setup Window”
(page 13) in the section “dspMixFx UR824” or the
“Master Levels Window” (page 19) in the section
“Dedicated Windows for Cubase Series.”
@ Power button
Turn the power on and off.
Lamp Clock Source
WCLK The word clock signal input to the
WCLK IN.
ADAT A The word clock signal input to the
OPTICAL A IN.
ADAT B The word clock signal input to the
OPTICAL B IN.
INTERNAL The internal word clock signal.
Lamp status Description
Lit Synchronized with the clock
source.
Flash Not synchronized with the clock
source.
Lamp Sample Rate
96k and 48k 192 kHz
88k and 44k 176.4 kHz
96k 96 kHz
88k 88.2 kHz
48k 48 kHz
44k 44.1 kHz
Power on Press the power button ( ). The
power button will light.
Power off Hold down the power button ( )
for over two seconds. The power
button will light dimly.