User Manual

Appendix
UR824 Operation Manual 34
*1The following chart indicates an effect insertion location.
*2 One of the MIX 1–4 signals can be sent to the REV-X.
*3 The built-in REV-X is equipped with an “FX Bus” which is used for sending the signal from DAW software to
the REV-X. For example, to send the recorded audio data to the REV-X, you can check the sound with the
REV-X, which is used for monitoring during the recording.
Limitations on the use of effects
The maximum number of Channel Strip and Guitar Amp Classics iterations which can be used simultaneously
are limited to the following. For example, Channel Strip can be used for four mono channels and two stereo
channels, while Guitar Amp Classics can be used for one mono channel simultaneously.
Please note that you cannot use the effect when the sample rate is set to 176.4 kHz or 192 kHz.
Effect
Effect
Upper (INS.FX)
From input on the device
To DAW
input
To DAW
input
To DAW
input
To output on the device
Lower (MON.FX)
From input on the device
To output on the device
Not applied (OFF)
From input on the device
To output on the device
Channel Strip Guitar Amp Classics
Mono Stereo Mono Stereo
801-
611-
421-
231-
041-