User Manual

Panel Controls for the Software Programs
UR824 Operation Manual 19
Master Levels Window
This is the window for configuring the master level of
the output jacks on the device.
1 Knob Control
Selects which LINE OUTPUT signal level is to be
adjusted by the OUTPUT LEVEL knob on the
device. You can select more than one LINE
OUTPUT at the same time. Checkmarks indicate
the selected LINE OUTPUT signals.
2 Master Source
Indicates the LINE OUTPUT.
3 Master Level
Indicates the output signal level of the LINE
OUTPUT.
4 Master Level knob
Adjusts the output signal level of the selected
(highlighted) LINE OUTPUT signal. Please note
that this Master Level Knob will not appear when
selecting a LINE OUTPUT with a checkmark on
the Knob Control.
5 Reset
Sets the output signal level of all LINE OUTPUT
signals not selected in the Knob Control to -∞ dB.
Settings Window
This is the window for configuring the device
settings.
1 HPF
Selects the cutoff frequency of the high pass filter.
Option: 120 Hz, 100 Hz, 80 Hz, 60 Hz, 40 Hz
2 DIGITAL MODE
Selects the input and output signal format of the
OPTICAL A/B.
When ADAT is selected, the OPTICAL A/B
terminals input and output signals of up to eight
channels at 44.1 kHz and 48 kHz, or up to four
channels at 88.2 kHz and 96 kHz, or up to two
channels at 176.4 kHz and 192 kHz. When S/PDIF
is selected, the OPTICAL A/B terminals input and
output signals of up to two channels at any
available sample rate.
3 LOOPBACK
Turns the Loopback function on (lit) and off
(dark). Refer to the “LOOPBACK” in the section
“dspMixFx UR824” (page 14).
Option Description
ADAT This is an input and output signal
format supporting up to 8 channels.
S/PDIF This is a 2-channel input and output
signal format.