User Manual

Panel Controls for the Software Programs
UR824 Operation Manual 11
Channel Area
This is the area for configuring the input channel
settings.
1 Channel Link
Turns on (lit) and off (dark) the channel link of two
adjacent channels. When you turn this on, two
mono channels will become one stereo channel.
2 Level Meter
Indicates the signal level.
3 High Pass Filter
Turns on (lit) and off (dark) the high pass filter.
To select the cutoff frequency of the high pass
filter, use the “Setup Window” (page 13) in the
section “dspMixFx UR824.”
4 Phase
Turns on (lit) and off (dark) the phase inversion of
the signal.
5 Effect Insertion Location
Selects the insertion location of an effect.
6 Effect On/Off
Turns the effect on (lit) and off (dark).
7 Effect Edit
Opens (lit) and closes (dark) the selected effect
setup window.
8 Effect Type
Selects the effect.The maximum number of
Channel Strip and Guitar Amp Classics iterations
which can be used simultaneously has
restrictions. Refer to the “Limitations on the use of
effects” (page 34).
9 REV-X Send
Adjusts the signal level which is sent to the
REV-X.
Range: -∞ dB – +6.00 dB
) Pan
Adjusts the pan.
Range: L16 – C – R16
! Mute
Turns the mute on (lit) and off (dark).
@ Solo
Turns the solo on (lit) and off (dark).
# +48V
Indicates the on/off status of the phantom power
function of the device.
$ Fader
Adjusts the signal level.
Range: -∞ dB – +6.00 dB
Option Description
MON.FX Applies an effect to only the monitor
signal (sent to the device).
INS.FX Applies an effect to both the monitor
signal (sent to the device) and the
recording signal (sent to the DAW
software).