User Manual

12.30 Steinberg Studio Chorus 365
12.30 Steinberg Studio Chorus
The StudioChorus plug-in is a two stage chorus effect which adds short delays to the signal
and pitch modulates the delayed signals to produce a "doubling" effect. The two separate
stages of chorus modulation are completely independent and are processed serially (cas-
caded).
For each stage the following parameters are available:
Rate
This is where you specify the base note value which may be set freely with the Rate
knob.
Width
Determines the extent of the chorus effect. Higher settings produce a more pronounced
effect.
Spatial
Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.
Mix
Sets the level balance between the dry signal and the effect. If StudioChorus is used as
a send effect, set this to the maximum value as you can control the dry/effect balance
with the send.
Waveform Shape button
Allows you to select the modulation waveform, altering the character of the chorus
sweep. A sine and a triangle waveform are available.
Delay
Affects the frequency range of the modulation sweep by adjusting the initial delay time.
Filter Lo/Hi
Allow you to roll off low and high frequencies of the effect signal.
Note that the modulation can also be controlled from another signal source via the side-chain
input. When the sidechain signal exceeds the threshold, the modulation is controlled by the
side-chain signal's envelope.
WaveLab 7