User Manual

Editing Layers
Modulation Matrix
65
switched between unipolar and bipolar. An additional modifier and user-definable curves and
ranges give you further control over the modulation.
The modulation matrix is divided into two sections. On the left, you can assign modulation
sources to destinations and adjust the modulation depth. The section on the right contains
settings for the curve and range editor, where you can make further settings for the selected
modulation source.
Creating Modulations
PROCEDURE
1. Select the synth or sample layer that you want to adjust.
2. Click Show Modulation Matrix.
3. Select a modulation source and a modulation destination, for example, LFO1 as source
and Pitch as destination.
4. Use the horizontal fader below the destination to adjust the modulation depth.
5. Optional: Click the Source 2 field and select a modifier or change the polarity of the
source.
For example, select Pitch Bend as modifier and set it to unipolar.
6. Optional: Use the curve and range settings on the right to limit the modulation range
or to adjust the characteristics of the modulation.
Modulation Matrix Context Menu
Cut Modulation
Cuts the modulation data from the current slot.
Copy Modulation
Copies the modulation data from the current slot to the clipboard.
Paste Modulation
Pastes the modulation data from the clipboard to the current modulation slot.