3.0

93
The Multi Zone
The Editor Page
SOLO
If you activate this button, the selected pad is soloed during playback.
VMax
If you activate this button, all pads are played back with the maximum velocity value of
127.
Reset
If you click this button, all pad assignments on the Beat Page are cleared.
Sound Editing Parameters
The section below the waveform display contains sound editing parameters, distributed
to three tabs: Amp, Filter, and Voice.
On the Amp tab, the following parameters are available:
On the Filter tab, the following parameters are available:
On the Voice tab, the following parameters are displayed:
Parameter Description
Attack Controls the amplifier envelope’s attack time.
Release Controls the amplifier envelope’s release time. Reduce the release
time to shorten the decay of sounds played in one-shot mode.
AmpMod Determines the influence that the velocity has on the pad volume
setting. When set to 100
%, the pad sounds louder, the higher the
velocity. When set to 0
%, velocity has no effect on the pad volume.
AttMod Determines the influence that the velocity has on the Attack setting.
The higher the AttMod setting, the longer the additional attack time for
a pad. When this parameter is set to 100
% and you are playing a pad
with high velocity, the attack time is increased by 50
%. When set to
0
%, velocity has no effect on the attack.
Parameter Description
Off, LP, HP, BP Sets the filter type: low-pass (LP), high-pass (HP), or band-pass (BP).
When you set this control to Off, the settings on this tab have no effect.
CutOff Sets the filter’s cutoff frequency.
Q Sets the filter’s resonance.
Mod Determines the influence that the velocity has on the cutoff frequency.
When set to 0
%, the setting has no effect. When set to any other value,
the cutoff frequency changes depending on the velocity.
Parameter Description
Coarse Tunes the pad by up to ±12 semitones.
Fine Fine-tunes the pad by up to ±100 cents.
Reverse Reverses the selected sample so that you hear it backwards.
Trigger Mode Set this to “One Shot” to play the sample of the selected pad from
start to finish, or to “Key Hold” to play the sample for as long as you
hold the mouse button.