3.0

91
The Multi Zone
The Editor Page
Flam
A flam is a short secondary drum hit that is played just before or after the actual main
drum beat. If you want to add a flam to a step, proceed as follows:
1. Activate the “Flam Edit Mode” button to the right of the flam function.
2. In the step display, click a step.
A small dot representing a flam appears.
3. Click the Flam value field and drag up or down to adjust the flam value.
This way you can specify whether if the flam is positioned before the beat or after it.
Lane Selectors
The 16 lane selectors on the left of the Beat Page match the 16 pads shown in the
pad section on the right.
• If you select another pad group in the pad section, the corresponding lanes are
displayed on the left.
• If you click a lane, the assigned instrument is triggered.
The same happens if you select a pad or edit a step in the step display.
Lane Offset
When you move the mouse pointer over a lane, the Lane Offset slider is displayed. It
allows you to offset all drum steps of a lane.
• Drag the slider to the left to let the drum steps start a little earlier or to the right to
start them later.
Step Display
The step display contains 16 steps for each lane.
• To enter a drum step, click in the step field.
When you click in an empty field, it is filled, indicating that you will hear a drum beat
on this step.
• To enter a continuous range of drum steps, click and drag.
• To remove a drum step, click the corresponding field again.
• To remove a range of drum steps, click and drag over them.
• To set a high velocity value, click in the upper part of the field when entering a step,
to set a low velocity value, click in the lower part.
The different velocity settings are indicated by different colors.
Ö
The velocity of a flam is slightly lower than the velocity of the corresponding step.