3.0

55
The Beat Page
Editing Pattern Parts
Editing the Velocity
You can edit the velocity in the following ways:
• Fine-tune the velocity for a step by clicking it and dragging up or down.
The current velocity value is shown while you drag, allowing you to find the
corresponding setting easily.
• Fine-tune the velocity for a range of steps by clicking the first step, dragging up or
down while holding the mouse button pressed to enter into velocity edit mode, and
then dragging sideways and up or down to modify the velocity for all the steps.
• Change the velocity for all steps on a lane by holding down [Shift] while dragging
up or down.
The velocity for the steps is increased or decreased by the same amount. The
relative velocity differences of the steps are kept for as long as possible, that is,
until the minimum or maximum setting is reached.
• Create a crescendo or decrescendo for a range of steps by holding down
[Alt]/[Option], clicking the first step, dragging up or down and then dragging to the
left or right while keeping the mouse button pressed.
Editing Pattern Parts
Creating Pattern Parts
To create a pattern part, proceed as follows:
1. Drag a pattern selector pad and drop it on a beat track.
2. On the Beat Page, click the second pattern selector pad and set up a new pattern
in the step display.
3. Create more patterns and drag them onto your beat track.
You can create up to 12 beat patterns. These are automatically stored on the
selected selector pad.
Drop a pattern selector
pad on a beat track…
…to create a pattern part.