3.0

44
Mixing
Adding Automation
Output Effects
Output effects are like insert effects, but are applied to the Master channel. Open the
“Output Effects” section by clicking the button in the lower right of the Multi Zone.
The Output Effects section features three assignable effects and a fixed Maximizer
effect. The effects are controlled via sliders and a Bypass button.
• Use the Maximizer to raise the overall volume of the project.
1. Move the Optimize slider until the effect is at a suitable level.
2. You can bypass the effect by clicking the Bypass button.
For details on each effect and its parameters, see the chapter “Effects and
Instruments Reference” on page 119.
Adding Automation
You can use an automation to adjust faders, pan, knobs, and effects automatically.
This is very handy, especially when you have a lot of tracks in your project. Any
changes you make are remembered and occur again automatically.
• Load the project “Mixing 8” found in the “Sequel Tutorial 3” folder.
!
Any automation you have created is always reproduced during playback, even if the
automation data is not shown. If you do not want the automation to be reproduced,
delete all automation data you recorded on your tracks.