3.0

43
Mixing
Audio Effects
6. Add a flanger to the Synth track to make it stand out a little bit more. Select the
Synth track in the Arrange Zone.
7. Open the first insert slot, and choose Flanger from the Modulation submenu.
8. Make changes to the effect manually, or select a preset from the Preset pop-up
menu.
For details on each effect and its parameters, see the chapter “Effects and
Instruments Reference” on page 119.
At the end of this section, you can load the next tutorial that contains all changes you
have made.
Send Effects
• Load the project “Mixing 7” found in the “Sequel Tutorial 3” folder.
Each project can have two send effects.
1. Make sure you have the Track Inspector Page selected and open the Send Effects
panels.
Reverb and StereoDelay are set as the default send effects. You can change them if
you like, but remember you only have two slots that are used for all tracks.
Add some reverb to the drums:
2. Select the Drums track and make sure “Amount 1” is enabled. This sends the
drums to the Reverb effect.
3. Move the “Amount 1” slider until you are satisfied with the sound.
For details on each effect and its parameters, see the chapter “Effects and
Instruments Reference” on page 119.
Effect Preset
menu
Send effect 1
Send effect 2
Amount 1
enabled