3.0

24
Recording
Recording Audio
Playback
To listen to what you have just recorded, you have to play it back.
• Load the project “Playback” found in the “Sequel Tutorial 1” folder.
Starting Playback
To start playback, you have the following possibilities:
• Click the Play button.
• Press [Space] on your computer keyboard.
This toggles between start and stop.
• Press [Enter] on the numeric keypad.
• Double-click in the lower half of the ruler.
Stopping Playback
To stop playback, you have the following possibilities:
• Click the Play button during playback.
• Press [Space] on your computer keyboard.
This toggles between start and stop.
• Press [0] on the numeric keypad.
Cycle Playback
In Sequel, you can also cycle (or loop) a section of your project.
To draw in a cycle region, proceed as follows:
1. Click the button on the right of the ruler to activate “Snap to Grid”.
This makes it easier to create a precise region.
2. Position the mouse pointer over the top of the ruler, so that it turns into a Draw
tool.
3. Click and drag from bar 3 to bar 4.
4. Activate the Cycle button.
5. Click the “Jump to Previous Marker” or “Jump to Next Marker” buttons until the
project cursor is positioned at the beginning of the cycle (in this example, bar 3).
6. Start playback.
Sequel plays the cycle section over and over again until you stop playback.