1.0

12
Tutorial 1: Recording
The tutorials
The following chapters provide a quick introduction to Se-
quel. But first, please take a look at the figure below, as it
gives you an overview of the Sequel program interface:
In this first tutorial, we are going to show you how the Pilot
Zone, Arrange Zone, and Multi Zone work together when
recording audio events and Instrument parts.
Recording audio
In this section, we are going to take a look at recording a
guitar line into a project, adding in a drum loop and playing
it back. Make sure that you have your audio card set up.
For detailed information on the audio setup, see the chap-
ter “Setting up your system” on page 80.
Creating a new project
By default, Sequel creates a new project when you boot
up the program. You can change this in the “Program Set-
tings Page”. See the chapter “The Program Settings
page” on page 71 for more details.
To create a new project if a project is already open
• Click the “New Project” button in the Pilot Zone.
This will create a new project with nothing in it and close
the project that was already open. If this contains unsaved
changes, you will be asked whether these changes should
be saved.
The Pilot Zone is explained
in the chapter “The Pilot
Zone” on page 37.
Details on the Arrange
Zone can be found in the
chapter “The Arrange
Zone” on page 48.
The Multi Zone and its various
pages are described in the
chapter “The Multi Zone” on
page 55.
!
You’re not done yet! So far we’ve created a blank
Sequel project. We still need to save the project.