User manual

Table Of Contents

Hiding/Showing brackets for right-hand ngerings

When multiple notes in the same chord are plucked by the same right-hand nger, you can show

the same

ngering multiple times, once for each note, or show a single ngering for all notes

with a bracket spanning the notes plucked by that nger. When showing a separate ngering for

each note, you can also choose to place each ngering either above or below the staff. You can

do this for the current layout and frame chain only or for all layouts and frame chains.

NOTE

These steps only apply to right-hand ngerings belonging to fretted instruments.

PREREQUISITE

●

You have input the ngerings for which you want to hide/show brackets or whose vertical

position you want to change.

●

You have chosen the appropriate property scope for local properties.

PROCEDURE

Select all the notes for which you want to hide/show brackets for right-hand ngerings.

In the Properties panel, activate Vertical position in the Plucked Fingering group.

3. Select one of the following options from the menu:

● To hide brackets and show a separate ngering for each selected note, select Above

staff or Below staff.

● To show brackets and a single ngering for all notes in each bracket, select Next to

note.

RESULT

Brackets on the selected right-hand ngerings are hidden/shown. If you selected Above staff or

Below staff, their staff-relative placement is changed accordingly. If the property scope was set

to Locally, this change only takes effect in the current layout and frame chain.

EXAMPLE

Right-hand

ngerings shown next

to notes with a bracket

Right-hand ngerings shown

above the staff

Right-hand ngerings shown

below the staff