User manual

Table Of Contents

TIP

You can also input slash regions by clicking Create Slash Region in the Rhythm Slashes group

of the Repeat Structures panel.

RELATED LINKS

Repeats popover on page 322

Rhythm slashes on page 869

Slash regions on page 869

Slash voices on page 1001

Inputting bar repeats

You can input bar repeat regions when at least one bar before the region contains notes.

PROCEDURE

In Write mode, select the bars on a single staff that you want to show as a bar repeat.

NOTE

You cannot input bar repeat regions in the rst bar of a ow.

2. Press Shift-R to open the repeats popover.

3. Enter the appropriate entry for the type of bar repeat region you want into the popover.

For example, enter %2,2 to repeat the previous two bars, grouped in two.

4. Press Return to close the popover.

RESULT

A region of the selected duration is input, in which the specied type of bar repeat symbol is

shown in the staff at the intervals

specied.

NOTE

● You can also input bar repeat regions during note input; however, this inputs bar repeat

regions from the bar containing the currently selected note. As bar repeats are mostly

shown in empty bars, this is likely to produce unintended results.

● You can also input bar repeat regions by clicking Create Bar Repeat Region in the Bar

Repeats group of the Repeat Structures panel. However, this only inputs a bar repeat region

containing single-bar repeats.

AFTER COMPLETING THIS TASK

You can change how bar repeats are grouped.