User manual

Table Of Contents

The Video Properties dialog contains the following elds and options:

Video le

Shows the location of the video le on your computer. This eld is read-only.

Video frame rate

Shows the frame rate of the video le. This eld is read-only.

Project frame rate

Allows you to select a frame rate for your project from the menu. You can only have a

single frame rate across the project.

Use video frame rate

Sets the project frame rate to be the same as the video le.

Flow attachment position

Allows you to set the rhythmic position at which the video attaches. This is set using

the Beat count and Beat unit settings in combination, such as eight dotted quarter

notes.

Video start offset

Allows you to set a position within the video that syncs with the ow attachment

position, for example, you can set the

fth second of the video to attach to the start of

the third bar.

Timecode start

Allows you to set the timecode at the start of the video. This also affects the timecode

of the

ow, but the initial timecode of the ow adjusts to accommodate the video. For

example, if the initial timecode of the video is 02:00:00:00 but the video does not start

until the start of the third bar in 4/4, the initial timecode of the

ow is eight beats of

time less than 02:00:00:00; if the tempo is 60 bpm, this makes the initial ow timecode

01:59:52:00.

NOTE

Flow timecodes are shown in their ow cards in the Flows panel.