User manual

Table Of Contents

Changing the duration of tremolos in playback

You can change both the default length of each note in unmeasured tremolos in playback, and

the minimum number of tremolo strokes required to indicate tremolos should be unmeasured in

playback.

For example, to change the value in the value eld to set the default length to 0.5 seconds, enter

1 into the value eld, or click the arrows beside the value eld to change the value, for Default

unmeasured tremolo length in the Tremolos section on the Timing page in Playback Options.

TIP

If you hover over either of the arrows beside the Default unmeasured tremolo length value

eld, a small box appears that displays the current fraction as a decimal.

PROCEDURE

1. In Play mode, choose Play > Playback Options.

The Playback Options dialog opens.

2. Click Timing in the page list.

3. Optional: In the Tremolos section, change the value for Minimum number of strokes for

playback of unmeasured tremolos in any of the following ways:

● Enter a value into the value eld.

● Click the arrows beside the value eld.

4. Change the value for Default unmeasured tremolo length in any of the following ways:

● Enter a value into the value eld.

● Click the arrows beside the value eld.

For example, to set the default length of unmeasured tremolo notes to 0.5 seconds,

change the value to 1.

TIP

If you hover over either of the arrows beside the value eld, a small box appears that

displays the current fraction as a decimal.

5. Click Apply, then Close.

RESULT

The sounding duration of each note in unmeasured tremolos in playback is changed project-

wide.

Changing the value for Minimum number of strokes for playback of unmeasured tremolos

changes the minimum number of tremolo strokes required for tremolos to be unmeasured in

playback.