User manual

PROCEDURE
1. In Engrave mode, select the slash region counts you want to move.
2. Move the selected slash region counts in any of the following ways:
● Press Alt-Right Arrow to move them to the right.
● Press Alt-Left Arrow to move them to the left.
● Press Alt-Up Arrow to move them upwards.
● Press Alt-Down Arrow to move them downwards.
TIP
If you want to move items by larger increments, you can press Ctrl/Cmd as well as
the standard key command, for example, Ctrl/Cmd-Alt-Left Arrow.
●
Click and drag them in any direction.
RESULT
The selected slash region counts are moved to new graphical positions.
TIP
Count offset in the Slash Regions group of the Properties panel is activated automatically when
you move slash region counts in the corresponding directions:
● Count offset X moves slash region counts horizontally.
● Count offset Y moves slash region counts vertically.
You can also use this property to move slash region counts graphically by changing the values in
the value elds.
Deactivating the property resets the selected slash region counts to their default positions.
RELATED LINKS
Changing the start count of slash regions on page 626
Changing the placement of slash region counts relative to the staff on page 628
Changing the placement of slash region counts relative to the staff
You can change whether counts on individual slash regions appear above or below the staff,
independently of your project-wide setting.
NOTE
Changing the placement of slash region counts relative to the staff affects all counts on the
region. You cannot change the placement of a single count independently of other counts on the
same slash region.
PROCEDURE
1. Select any part of each slash region whose count staff-relative placement you want to
change.
2. In the Properties panel, activate Count position in the Slash Regions group.
3. Choose one of the following options:
●
Above
●
Below
Rhythm slashes
Slash region counts
628