User manual

NOTE
Slash region counts use the same font style as bar repeat counts.
RELATED LINKS
Slash regions on page 619
Project-wide engraving options for rhythm slashes on page 620
Changing the start count of slash regions on page 626
Changing the slash region count frequency on page 626
Changing the slash region count appearance on page 627
Changing the bar repeat count font on page 615
Changing the start count of slash regions
You can change the number from which individual slash region counts start, for example, if you
want to input more precise notation between two slash regions but want the count to appear to
continue across the regions.
PROCEDURE
1. Select any part of each slash region whose start count you want to change.
2. In the Properties panel, activate Count from in the Slash Regions group.
3. Change the value in the value eld in any of the following ways:
● Enter a value into the value eld.
● Click the arrows beside the value eld.
RESULT
The number and position of counts on the selected slash regions is changed. For example,
changing the start count from 1 to 2, with counts shown every four bars, causes the count to
appear on the third bar in the slash region instead of the fourth.
EXAMPLE
Two separate slash regions, where the start count on the second region has been changed so it appears to
continue on from the rst region.
RELATED LINKS
Slash region counts on page 625
Changing the slash region count frequency
You can change how frequently counts are shown on slash regions independently of your
project-wide setting, for example, if you want to show the count after eight bars on a single slash
region. By default, slash region counts are shown every four bars.
PROCEDURE
1. Select any part of each slash region whose count frequency you want to change.
2. In the Properties panel, activate Count frequency in the Slash Regions group.
3. Change the value in the value eld in any of the following ways:
Rhythm slashes
Slash region counts
626