User manual

Table Of Contents

EXAMPLE

Separate bar repeats on multiple systems in the

same part layout with the default count

Separate bar repeats on multiple systems in the

same part layout with their counts changed to imply

a continuous region

RELATED LINKS

Bar repeat counts on page 612

Changing the bar repeat count frequency

You can change how often counts are shown on individual one-bar repeat regions independently

of your project-wide setting, for example, if you want to show the count after eight bars on a

single bar repeat region.

NOTE

Bar repeat counts are only shown on one-bar repeat regions.

PROCEDURE

1. Select the one-bar repeats whose count frequency you want to change.

2. In the Properties panel, activate Count frequency in the Bar Repeat Regions group.

3. Change the value in the value eld in any of the following ways:

● Enter a value into the value eld.

● Click the arrows beside the value eld.

RESULT

The count frequency is changed for the selected bar repeat regions.

TIP

You can also change the default count frequency for all bar repeat regions project-wide on the

Bar Repeats page in Engrave > Engraving Options.