User manual

Changing the end level of pedal lines
You can change the end level of individual sustain pedal lines by moving end level handles
upwards/downwards.
PROCEDURE
1. In Engrave mode, select the right handles on the end hooks whose end pedal levels you
want to change.
TIP
You can show handles on all items, not just selected items, by choosing Engrave > Show
Handles > Always. This can make it easier to select individual handles on multiple items.
2. Move the end level handles in any of the following ways:
●
Press Alt-Up Arrow to move them upwards.
●
Press Alt-Down Arrow to move them downwards.
●
Press Ctrl/Cmd-Alt-Up Arrow to snap the level to 0 (not depressed).
●
Press Ctrl/Cmd-Alt-Down Arrow to snap the level to 1 (fully depressed).
●
Click and drag the handles upwards/downwards to the level you want.
RESULT
The end levels of the selected pedal lines are changed.
TIP
End level in the Pedal Lines group of the Properties panel is activated when you change the end
level of pedal lines.
You can also use this property to change the end level of pedal lines by changing the value in the
value eld. For example, 1 is fully depressed and 0 is not depressed.
Deactivating the property resets the selected pedal lines to their default end level.
RELATED LINKS
Sustain pedal lines in Engrave mode on page 549
Removing retakes and pedal level changes
You can remove pedal retakes and level changes without deleting the sustain pedal line or
changing its rhythmic position.
PROCEDURE
1. In Write mode, select the note at the rhythmic position of the retake or pedal level change
you want to remove.
NOTE
You can only remove one retake or pedal level change at a time.
2. Remove the retake or pedal level change in any of the following ways:
●
Open the playing techniques popover, enter nonotch into the popover, then press
Return.
Pedal lines
Sustain pedal retakes and pedal level changes
554