User manual

EXAMPLE
Example pedal line with retake and level changes
1 Ped. glyph
2
Retake
3
One quarter depressed
4
Half depressed
5
Three quarters depressed
6
Fully depressed
7
Line end hook
RELATED LINKS
Sustain pedal lines in Engrave mode on page 549
Removing retakes and pedal level changes on page 554
Input methods for pedal lines, retakes, and pedal level changes on page 217
Sustain pedal lines in Engrave mode
When you select sustain pedal lines in Engrave mode, handles appear at the start/end of each
pedal line, and on any retakes or pedal level changes on the line. These handles allow you to
move each part of the pedal line independently, and to change the pedal levels at the start, end,
and at each retake or pedal level change.
A sustain pedal with a retake in Engrave mode
There are two handles for the start of the pedal line, three for retakes and pedal level changes,
and three for the end of the pedal line.
NOTE
Sostenuto and una corda pedal lines only have a single handle at their start/end, which allows you
to move their start/end positions graphically, but only horizontally.
You can move each handle with the keyboard, with the mouse, and using the Properties panel.
Each handle corresponds to a property in either the Pedal Lines group or the Pedal Line
Retakes group of the Properties panel.
NOTE
Pedal levels cannot be lower than 0 or higher than 1.
● 1 is fully depressed.
● 0 is not depressed.
Pedal lines
Sustain pedal retakes and pedal level changes
549