User manual

RELATED LINKS
Tremolos on page 744
Input methods for repeats and tremolos on page 232
Deleting tremolos on page 747
Changing the appearance of multi-note half note tremolos project-wide on page 750
Inputting slash regions
You can input slash regions using the repeats popover.
PROCEDURE
1. In Write mode, select the region in which you want to show rhythm slashes.
2. Open the repeats popover in any of the following ways:
●
Press Shift-R.
●
Choose Write > Create Repeat.
3. Enter slash into the popover.
4. Press Return to close the popover.
RESULT
A region of the selected duration is input, in which rhythm slashes are automatically shown and
formatted as appropriate for the meter. If you later change the time signature, the slash region
retains its duration but the appearance of the slashes automatically updates.
TIP
You can also input slash regions by clicking Create Slash Region in the Rhythm Slashes group
of the Repeat Structures panel.
RELATED LINKS
Repeats popover on page 234
Rhythm slashes on page 619
Slash regions on page 619
Slash voices on page 789
Input methods for repeats and tremolos on page 232
Inputting bar repeats
You can input bar repeat regions when at least one bar before the region contains notes.
PROCEDURE
1. In Write mode, select the bars you want to show as a bar repeat.
NOTE
●
Your selection must follow at least a single bar that contains notes.
●
You can only input bar repeat regions on one staff at a time.
2. Open the repeats popover in any of the following ways:
●
Press Shift-R.
●
Choose Write > Create Repeat.
3. Enter the appropriate short-hand for the type of bar repeat region you want into the
popover.
For example, enter %2,2 to repeat the previous two bars, grouped in two.
Write mode
Notations input
243