User manual

Table Of Contents

RELATED LINKS

Input methods for repeats and tremolos on page 232

Inputting tremolos with the popover

You can input both single-note and multi-note tremolos using the repeats popover, both during

step input and by adding them to existing notes.

PROCEDURE

1. In Write mode, do one of the following:

● Start note input.

TIP

During note input, you can select additional notes before/after the last input note

without deactivating the caret by pressing Shift-Right Arrow/Left Arrow.

●

Select the notes to which you want to add tremolos.

NOTE

If you want to input multi-note tremolos, you must select at least two notes, which

can also be tuplets.

2. Open the repeats popover in any of the following ways:

● Press Shift-R.

● Choose Write > Create Repeat.

3. Enter the appropriate short-hand for the type of tremolo you want into the popover.

For example, to input a three-stroke multi-note tremolo, enter ///2.

4. Press Return to close the popover.

5. Optional: Repeat steps 2 to 3 to input other tremolos on the selected notes.

For example, if you want notes to have both single-stem and multi-stem tremolos.

RESULT

Single-note tremolos are input on the selected notes with the number of tremolo strokes

specied.

Multi-note tremolos with the number of tremolo strokes specied are input between selected

individual notes and the notes immediately after them, or between selected pairs of notes.

When tuplets are selected, multi-note tremolos are input across the selected tuplets, with the

tremolo strokes positioned in the center of all notes in the tuplet. The tuplet bracket is hidden,

and a signpost is shown at the start of each tuplet indicating its ratio.

EXAMPLE

Multi-note tremolos with three tremolo strokes across tuplets