3.0

CUBASE SX/SL
11 – 42 Yamaha 01V
Specifications
The Yamaha 01V can remote control either the Cubase SX/SL mixer
or the Yamaha DSP Factory if installed (Windows only; see the sepa-
rate “Using Cubase SX/SL with DSP Factory” document for details).
Before you can initiate remote control operation, the 01V must be set
up in the following way:
• MIDI Parameter Change and Receive must be enabled.
• MIDI Control Change and Receive must be disabled.
• Device ID / MIDI Channel Receive must be set to “1”.
• Local Control should be set to “Off”.
As soon as Local Control is set to “Off”, remote control of the mixer is enabled.
The 01V remote operation of the Cubase SX/SL mixer is very straight-
forward, with (almost) every parameter having the equivalent parame-
ter controller in the 01V mixer. The current status of all controllable
parameters is fed back to the 01V and indicated on the panel, using
the motorized faders, indicators, etc. (for this to work, you need a two-
way MIDI connection between the 01V and Cubase SX/SL).
To facilitate 32 channel remote control, two separate control “Layouts”
are used, each controlling 16 mixer channels. The “Memory” button on
the 01V is used to switch between VST layout 1 and 2 (when using
Cubase SX/SL for Windows there are also two layouts for the DSP
Factory – see the “Using Cubase SX/SL with DSP Factory” docu-
ment). Page 1 displays VST Layout 1, page 2 VST Layout 2, page 3
DSP Factory Layout 1 and page 4 DSP Factory Layout 2.