3.0

CUBASE SE
4 – 64 Logical Presets, Transformer and Input Transformer
Set to fixed value
This sets the Action Target to the value specified in the Parameter 1
column.
Transpose to Scale
This is only available when Action Target is set to Value 1, and when the
filter conditions are specifically set up to find notes (a “Type = Note”
filter condition line has been added). When “Transpose to Scale” is se-
lected, you can specify a musical scale using the Parameter 1 and 2
columns. Parameter 1 is the key (C, C#, D, etc.) while Parameter 2 is
the type of scale (major, melodic or harmonic minor, etc.).
Each note will be transposed to the closest note in the selected scale.
Use Value 2
This is only available when Action Target is set to Value 1. If this op-
tion is selected, the Value 2 setting in each event will be copied to the
Value 1 setting.
For example, this would be useful if you are transforming all Modulation
controllers to Aftertouch events (since controllers use Value 2 for their
amount, while Aftertouch uses Value 1 – see the table on page 55).
Use Value 1
This is only available when Action Target is set to Value 2. If this op-
tion is selected, the Value 1 setting in each event will be copied to the
Value 2 setting.
Mirror
This is only available when Action Target is set to Value 1 or Value 2.
When this option is selected, the values will be “mirrored” or “flipped”
around the value set in the Parameter 1 column.
In the case of notes, this will invert the scale, with the key set in the
Parameter 1 column as “center point”.