3.0

CUBASE SE
4 – 54 Logical Presets, Transformer and Input Transformer
Conditions
The options in the Condition column have the following meaning (note
that the available Condition options depend on the Filter Target setting):
• The Conditions for the “Property” filter target are different, see page 58.
Below, the different Filter Targets (and their corresponding Condition
and Parameter options) are described in more detail.
Parameter 2 This column is only used if you have selected one of the “Range” op-
tions in the Condition column. Typically, this allows you to find all
events with values inside (or outside) the range between Parameter 1
and Parameter 2.
bool This allows you to insert the boolean operators And/Or, when creat-
ing conditions with multiple lines. See page 60.
Condition Events will be found if their Filter Target property…
Equal …has the exact same value as set up in the Parameter 1 column.
Unequal …has any value other than the one set up in the Parameter 1 column.
Bigger …has a value higher than the one set up in the Parameter 1 column.
Bigger or Equal …has a value that is the same as or higher than the one set up in the
Parameter 1 column.
Less …has a value lower than the one set up in the Parameter 1 column.
Less or Equal …has a value that is the same as or lower than the one set up in the
Parameter 1 column.
Inside Range …has a value that is between the values set up in the Parameter 1
and Parameter 2 columns. Note that Parameter 1 should be the lower
value and Parameter 2 the higher.
Outside Range …has a value that is not between the values set up in the Parameter 1
and Parameter 2 columns.
Note is equal to …is the note specified in the Parameter 1 column, regardless of oc-
tave (Pitch only). Lets you find e.g. all C notes, in all octaves.
Column Description