3.0

CUBASE SE
Logical Presets, Transformer and Input Transformer 4 – 53
Setting up filter conditions
General procedure
The upper list is where you set up the filter conditions, determining
which events to find. The list contains one or several conditions, each
on a separate line.
• If you want to start from scratch (as opposed to basing your settings on
an existing preset) you may want to initialize the settings by clicking the
Init button.
• To add a new line (condition) click the Add Line button to the right.
The new line is added at the bottom of the list. If there are many lines, you may need to
use the scrollbar to the right to view them.
• To remove a line, click anywhere on it to select it and click the Delete
Line button to the right.
You set up a filter condition line by clicking in the columns and selecting
options from the pop-up menus that appear. Here is a brief description
of the columns:
Column Description
Filter Target Here you select which property to look for when finding events. Your
choice here affects the available options in the other columns as well,
see below!
Condition This determines how the Logical Editor should compare the property
in the Filter Target column to the values in the Parameter columns
(Equal, Unequal, Bigger, etc. – see the separate table below). The
available options depend on the Filter Target setting.
Parameter 1 Here you set which value the event properties should be compared
to (a numeric value or a choice from a pop-up menu, depending on
the Filter Target).