9.5

Table Of Contents

Included Effect Plug-ins

Modulation Plug-ins

Speed

Speed selector (stop/slow/fast)

Allows you to control the speed of the Rotary in three steps.

Speed Change Mode

If this is set to the left, the speed selector settings are taken into account. If this is

set to the right, you can modulate the speed with the Speed Mod knob and/or with a

MIDI controller that you can select on the Speed Mod Control (MIDI) pop-up menu.

Speed Mod

If the Speed Change Mode setting is set to the right side, this knob allows you to

modulate the rotary speed.

Speed Mod Control (MIDI)

This pop-up menu allows you to select the MIDI controller that controls the Rotary

speed. If you do not want to use MIDI realtime control, set this to Automation. If you

select Pitchbend as MIDI controller, the speed changes with an up or down flick of

the bender. If other MIDI controllers are used, the speed changes at MIDI value 64.

Additional settings

Overdrive

Applies a soft overdrive or distortion.

CrossOver

Sets the crossover frequency (200 to 3000 Hz) between the low and high frequency

loudspeakers.

Horn

Slow

Allows for a fine adjustment of the high rotor slow speed.

Fast

Allows for a fine adjustment of the high rotor fast speed.

Accel.

Allows for a fine adjustment of the high rotor acceleration time.

Amp Mod

Controls the high rotor amplitude modulation.

Freq Mod

Controls the high rotor frequency modulation.

Bass

Slow

Allows for a fine adjustment of the low rotor slow speed.

Fast

Allows for a fine adjustment of the low rotor fast speed.

Accel.

Allows for a fine adjustment of the low rotor acceleration time.

Amp Mod

Adjusts the modulation depth of the amplitude.