9.5

Included Effect Plug-ins
Modulation Plug-ins
Cubase LE Cubase AI Cubase
Elements
Cubase
Artist
Cubase
Pro
Nuendo
Side-chain
support
– – – X X X
Rate
If tempo sync is activated, this is where you specify the base note value for tempo-
syncing the phaser sweep (1/1 to 1/32, straight, triplet, or dotted).
If tempo sync is deactivated, the sweep rate can be set freely with the Rate knob.
Sync
Activates/Deactivates tempo sync.
Width
Sets the intensity of the modulation effect between higher and lower frequencies.
Feedback
Determines the character of the phaser effect. Higher settings produce a more
pronounced effect.
Spatial
If you are using multi-channel audio, the Spatial parameter creates a 3-dimensional
impression by delaying modulation in each channel.
Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used
as a send effect, set this parameter to the maximum value as you can control the
dry/effect balance with the send.
Manual
If this option is activated, the flanger sweep is static, that is, no modulation takes
place.
If the Manual button is deactivated, a knob is available, allowing you to change the
sweep position manually.
Filter Lo/Hi
Allow you to roll off low and high frequencies of the effect signal.
NOTE
If side-chaining is supported, the modulation can also be controlled from another signal source
via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is
controlled by the side-chain signal’s envelope. For a description of how to set up side-chain
routing, see the Operation Manual.
81