9.5

Table Of Contents

Included Effect Plug-ins

Filter Plug-ins

High Cut Freq (3 Hz to 20 kHz, or Off)

This high-cut filter allows you to remove high-frequency noise. The filter is inactive

if the curve point is located all the way to the right. You can set the frequency either

in Hz or as a note value. If you enter a note value, the frequency is automatically

changed to Hz. For example, a note value of A3 sets the frequency to 440 Hz. When

you enter a note value, you can also enter a cent offset. For example, enter A5 -23 or

C4 +49.

NOTE

Ensure that you enter a space between the note and the cent offset. Only in this case,

the cent offsets are taken into account.

High Cut Slope

Allows you to choose a slope value for the high-cut filter.

High Cut Preview

This button between the High Cut Freq button and the graphical display allows

you to switch the filter to a complementary low-cut filter. This deactivates any other

filters, allowing you to listen only to the frequencies you want to filter out.

StepFilter

This plug-in is a pattern-controlled multimode filter that can create rhythmic, pulsating filter

effects.

Cubase LE Cubase AI Cubase

Elements

Cubase

Artist

Cubase

Pro

Nuendo

Included with – – X X X X

General Operation

StepFilter can produce two simultaneous 16-step patterns for the filter cutoff and resonance

parameters, synchronized to the sequencer tempo.

The horizontal axis shows the pattern steps 1 to 16 from left to right, and the vertical axis

determines the (relative) filter cutoff frequency and resonance settings. The higher up on

the vertical axis a step value is entered, the higher the relative filter cutoff frequency or filter

resonance setting.

By starting playback and editing the patterns for the cutoff and resonance parameters, you can

hear how your filter patterns affect the sound source connected to StepFilter.