9.5

Included Effect Plug-ins
Distortion Plug-ins
Blend – Blends between normal and tube emulation circuitry. With Blend at 0, Drive
and Presence are not active.
Bass – Boosts or attenuates low frequencies.
Treble – Boosts or attenuates high frequencies.
Presence – Boosts or attenuates upper harmonics and attacks.
Drive – Sets gain and overdrive.
Enhancer
Enhance – Simulates the classic enhancer effect.
Tone – Allows you to attenuate low frequencies.
Octaver
Direct – Adjusts the level of the original signal. A value of 0 means only the
generated and transposed signal is heard. By raising this value, more of the original
signal is heard.
Octave 1 – Adjusts the level of the signal that is generated one octave below the
original pitch. A setting of 0 means that the voice is muted.
Tone – Changes the sound character of the generated signal.
Delay
Delay – Sets the delay time in milliseconds. This parameter can be synchronized to
the project tempo.
Feedback – The higher this setting, the more delay repeats are created.
Mix – Sets the level balance between the dry signal and the wet signal.
Tape Ducking Delay
Delay – The Delay parameter sets the delay time in milliseconds.
Feedback – The higher this setting, the more delay repeats are created.
Duck – Works like an automatic mix parameter. If the level of the input signal is high,
the portion of the effect signal is lowered, or ducked (low internal mix value). If the
level of the input signal is low, the portion of the effect signal is raised (high internal
mix value). This way the delayed signal stays rather dry during loud or intensely
played passages.
Tone – Allows you to attenuate the low frequencies.
Mix – Sets the level balance between the dry signal and the wet signal.
Overdrive
Drive – Overdrive creates a tube-like overdrive effect. The higher this value, the more
harmonics are added to the output signal of this effect.
Tone – Works as a filter effect on the added harmonics.
Level – Adjusts the output level.
Magneto II
Drive – Controls the amount of tape saturation.
Low/High – These parameters set the frequency range of the spectrum band to
which the tape effect is applied.
HF-Adjust – Sets the amount of high frequency content of the saturated signal.
Gate
Threshold – Determines the level at which the gate is activated. Signal levels above
the set threshold open the gate and signal levels below the set threshold close the
gate.
Release – Sets the time after which the gate closes.
27