9.5

Included VST Instruments
Spector
Delay 1
Sets the delay time ranging from 0 ms to 728 ms. If MIDI sync is activated, the range
is from 1/32 to 1/1; straight, triplet or dotted.
Delay 2
Same as Delay 1.
Feedback
Controls the decay of the delays. With higher settings, the echoes repeat longer.
Filter
A low-pass filter is built into the feedback loop of the delay. This parameter controls
the cutoff frequency of this feedback filter. Low settings result in successive echoes
sounding darker.
Level
Controls the output level of the effect.
Modulation
You can choose between 3 basic modulation characteristics:
● Phaser uses an 8-pole all-pass filter to produce the classic phasing effect.
● Flanger is composed of two independent delay lines with feedback for the left and the
right channel. The delay time of both delays is modulated by one LFO with adjustable
frequency.
● Chorus produces a rich chorus effect with 4 delays modulated by four independent LFOs.
Song Sync
Activates/Deactivates tempo sync of the Rate parameter.
Rate
Sets the rate of the LFOs modulating the delay time. If Song Sync is activated, the
rate is synchronized to various beat increments.
Depth
Controls the depth of the delay time modulation.
Delay
Sets the delay time of the four delay lines.
Feedback
Controls the amount of positive or negative feedback for all four delay lines.
Level
Controls the output level of the effect.
SR Parameters
With these buttons, you can change the sample rate. Lower sample rates basically reduce the
high frequency content and sound quality, but the pitch is not altered. This is useful to emulate
the lo-fi sounds of older digital synths.
● If the F button is active, the program of the selected part plays back with the sample rate
set in the host application.
● If the 1/2 button is active, the program of the selected part plays back with half the original
sample rate.
● If the 1/4 button is active, the program of the selected part plays back with a quarter of the
original sample rate.
228