9.5

Included VST Instruments
Mystic
3. Using the same basic method, you can add any number of velocity destinations for the
LFO.
They are all listed in the Vel Dest box.
●
To remove a velocity destination, click on its name in the list and select Off from the
pop-up menu.
LFO modulation velocity control
If you follow the steps above and select the Cut parameter as a Velocity destination, the
following happens:
● The harder you strike the key, the more the Cut parameter is modulated by the LFO.
● If you enter a negative value for the velocity modulation amount, the opposite happens:
the harder you play, the less the Cut parameter is modulated by the LFO.
Envelope Page
The Envelope page is opened by clicking the ENV button at the top of the lower half of the
control panel. The page contains all parameters and the modulation and velocity destinations for
the four independent envelope generators.
Envelope generators govern how a parameter value changes when a key is pressed, when a key
is held and finally when a key is released.
On the Envelope page, the parameters for one of the four envelope generators is shown at a
time.
● You switch between the four envelopes in the section to the left.
Clicking on either of the four mini curve displays selects it and displays the corresponding
envelope parameters to the right.
● Envelope generators have four parameters: Attack, Decay, Sustain, and Release (ADSR).
● You can set envelope parameters in 2 ways: by using the sliders or by clicking and
dragging the curve in the Envelope curve display.
You can also do this in the mini curve displays.
● By default, Envelope 1 is assigned to the master volume, and therefore acts as an
amplitude envelope. The amplitude envelope adjusts how the volume of the sound
changes from the time you press a key until the key is released.
If no amplitude envelope is assigned, there is no output.
● Envelope 2 is by default assigned to the Level parameter.
The Envelope parameters are as follows:
Attack
The attack phase is the time it takes from zero to the maximum value. How long this
takes is governed by the Attack setting. If the Attack is set to 0, the maximum value
is reached instantly. If this value is raised, it takes time before the maximum value is
reached. Range is from 0.0 milliseconds to 91.1 seconds.
196