9.5

Included Effect Plug-ins
Distortion Plug-ins
To copy the settings of a scene to another scene, select the scene that you want to
copy, click Copy, and click one of the numbered buttons.
You can automate the selection of scenes.
Mix
Sets the level balance between the dry signal and the wet signal.
Output (-24 to 24 dB)
Sets the output level.
Band Settings
Mute
To mute each frequency band, activate the M button in each section.
Bypassing Frequency Bands
To bypass each frequency band, activate the Bypass Band button in each section.
Soloing Frequency Bands
To solo a frequency band, activate the S button in each section. Only one band can
be soloed at a time.
In/Out meter
Display the input and output level.
Gate
Determines the level at which the gate is activated. Signal levels above the set
threshold trigger the gate to open, and signal levels below the set threshold close
the gate.
Tape
This band mode simulates the saturation and compression of recording on analog tape
machines.
Drive
Controls the amount of tape saturation.
Tape Mode Dual
Simulates the use of two machines.
Tube
This band mode simulates the saturation effects using analog tubes.
Drive
Controls the amount of tube saturation.
Tubes
Determine the number of tubes that are simulated.
Dist
This band mode adds distortion to your tracks.
16